We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Red 1/0 gauge CCA power ground cable 25 ft roll

Bolton Technical

Bolton Technical 1/0 Gauge CCA Power Ground Cable 25 ft 2 in 1 accessory

SKU CH-137Q-29729

25-foot 1/0 gauge CCA power and ground cable with heat-tested UltraFlex jacket

  • 1/0 gauge cable delivers high current capacity for amplifier power and ground
  • UltraFlex heat-tested jacket resists temperature extremes in automotive environments
  • Pre-cut 25 foot roll eliminates measuring and cutting during installation
  • CCA construction provides lighter weight than solid copper while conducting power
  • International wire gauge standard ensures consistent diameter for reliable connections

1/0 Gauge CCA Power Ground Cable

The Bolton Technical 1/0 Gauge CCA Power Ground Cable is a 25-foot pre-cut roll designed for amplifier power and ground connections. It uses copper-clad aluminium conductors with an UltraFlex heat-tested jacket. The wire follows international gauge standards rather than AWG sizing. Installers receive a single 2-in-1 accessory length for both power and ground runs.

Replacing thinner or worn amplifier wiring

This cable replaces thinner gauge power or ground leads that cannot handle high-current amplifier demands. The jump is worth it when an existing run shows voltage drop, insulation damage or insufficient conductor area for the amplifier's rated draw. The 25-foot length suits typical vehicle cabin-to-boot routes without excessive slack. It is not for installations requiring AWG-certified sizing or pure copper conductors.

Fits standard amplifier power and ground terminals

The 1/0 gauge diameter fits common amplifier power and ground terminals and ring terminals sold for this gauge class. The UltraFlex jacket eases routing through tight firewall grommets and under carpet. The 2-in-1 roll frees the installer from buying separate power and ground spools. No specific tools, fuse holders or distribution blocks are included with the cable itself.

Highlights

  • 1/0 gauge cable delivers high current capacity for amplifier power and ground
  • UltraFlex heat-tested jacket resists temperature extremes in automotive environments
  • Pre-cut 25 foot roll eliminates measuring and cutting during installation
  • CCA construction provides lighter weight than solid copper while conducting power
  • International wire gauge standard ensures consistent diameter for reliable connections

Specifications

No published specifications for this item yet.

Questions about this item

What length and conductor type does this 1/0 gauge cable use?

The pre‑cut roll is 25 feet long and uses copper‑clad aluminum conductors with an UltraFlex heat‑tested jacket.

How should I route and terminate the cable to avoid the most common install error?

Keep the jacket away from sharp edges and moving parts, then crimp or solder lugs on both ends; the frequent mistake is using bare wire under a set‑screw terminal.

What signs tell me the cable needs replacement later?

Look for white oxidation on the aluminum core at connections, stiffness or cracking in the jacket after repeated heat cycles, or a measurable voltage drop under load.

New to this? Buying a laptop with crypto, start to finish — what to check, what it costs to pay, and what is never asked for.

More in 2 in 1 Accessories

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.