We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Stainless steel 90 degree sweep closet bend with push fit ends

Blucher

Blucher B2-90S-316 2" x 11-3/4" Push Fit 316 SS 90 Degree Sweep Closet Bend coupling

SKU CH-6T7C-FAEG0

A 316 stainless steel 90-degree sweep closet bend with push-fit connections for 2-inch drainage pipes, rated to 29 psi and finished pickled and passivated for corrosion resistance

  • Corrosion-resistant 316 stainless steel withstands harsh drainage environments
  • 90-degree sweep bend enables smooth right-angle flow changes
  • Push-fit socket and male ends speed up installation
  • 29 psi pressure rating supports reliable drainage performance
  • 51 mm outside diameter fits standard 2-inch piping

2-Inch 316 Stainless Sweep Bend

The Blucher B2-90S-316 is a 90-degree sweep closet bend made from grade 316 stainless steel for drainage systems. It provides a right-angle flow change between 2-inch pipes with a pickled and passivated finish for corrosion resistance. The push-fit design uses a female socket on one side and a male push-fit end on the other for direct assembly.

Push-Fit Installation Profile

The coupling connects by pushing the male end into the female socket, removing the need for solvent welding or threading tools during assembly. It accepts 2-inch nominal pipe with a 51 mm outside diameter on both ends, keeping the joint compact within the drainage layout. The sweep geometry maintains flow velocity through the bend without adding extra fittings to the run.

Replaces Threaded or Solvent Bends

Installers replacing threaded 90-degree elbows or solvent-weld sweep bends gain a joint that can be disconnected for maintenance without cutting pipe. The 29 psi pressure rating suits low-pressure drainage applications where metal durability is required. It is not suited for high-pressure supply lines or systems needing a straight coupling instead of a directional change.

Highlights

  • Corrosion-resistant 316 stainless steel withstands harsh drainage environments
  • 90-degree sweep bend enables smooth right-angle flow changes
  • Push-fit socket and male ends speed up installation
  • 29 psi pressure rating supports reliable drainage performance
  • 51 mm outside diameter fits standard 2-inch piping

Specifications

BrandBLUCHER

Questions about this item

How much pressure can the 316 stainless steel sweep bend handle before it becomes the limiting factor?

The fitting supports a maximum pressure of 29 psi within its specified operating conditions.

Does the push-fit 90-degree bend generate noticeable noise or heat when water runs through it continuously?

As a passive stainless steel fitting with pickled and passivated finish, it produces no noise or heat during continuous flow.

What pipe size and connection style must already be in place for this 2-inch closet bend to install correctly?

It requires 2-inch piping with a 51 mm outside diameter, accepting a female socket on one side and a male push-fit on the other.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.