We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two green DDR4 desktop DIMM modules with black heat spreaders

Blazing Memory

Blazing Memory BM16G2KITD42133DT 16GB DDR4 2133MHz 288-pin Kit

SKU CH-N0RD-0P6F1

A 16 GB DDR4 desktop memory kit with two 8 GB DIMMs running at 2133 MHz PC4-17000

  • 16 GB total capacity with two 8 GB modules
  • 2133 MHz DDR4 speed rated at PC4-17000
  • 288-pin DIMM form factor fits desktop boards
  • Non-ECC design for standard consumer systems
  • Manufactured in the United States

16 GB DDR4 kit for desktop builds

This Blazing Memory kit delivers 16 GB of DDR4 memory across two 8 GB modules. It runs at 2133 MHz with a PC4-17000 bus speed and uses standard 288-pin DIMM form factor. The non-ECC design targets mainstream desktop systems that do not require error correction.

Upgrade from single-channel or lower-capacity DDR4

Replacing a single stick or a smaller matched pair with this dual-channel kit enables full bandwidth on supported motherboards. The jump is worthwhile when the platform supports dual-channel DDR4 and the current memory limits multitasking or integrated-graphics performance.

Suits budget desktop builds and office refreshes

Builders assembling entry-level workstations or upgrading older office PCs will find the capacity and speed adequate. Enthusiasts chasing higher frequencies, lower latencies or ECC support should consider other memory lines that address those requirements.

Highlights

  • 16 GB total capacity with two 8 GB modules
  • 2133 MHz DDR4 speed rated at PC4-17000
  • 288-pin DIMM form factor fits desktop boards
  • Non-ECC design for standard consumer systems
  • Manufactured in the United States

Specifications

No published specifications for this item yet.

Questions about this item

Will the 288-pin DIMM modules fit my desktop motherboard slots?

Yes, each 8GB module uses the standard 288-pin DDR4 DIMM form factor designed for desktop motherboards with matching DDR4 slots.

What is the correct way to seat the two modules so the 16GB kit runs at 2133MHz?

Align the notch on each module with the slot key, press down firmly until both side clips click shut, then enable the PC4-17000 speed in BIOS if it does not set automatically.

When should I consider replacing the 16GB DDR4 kit?

Replace the kit if memory diagnostics report errors, the system fails to boot with both modules installed, or you need capacity beyond the 16GB total.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.