Big Horn
Big Horn 14108 Offset Trimmer Sub-Base for 7312 Laminate Trimmer
Offset sub-base fits 7312 laminate trimmers for backsplash trimming, wall scribing and 90-degree corners
- Offset base enables backsplash trimming and wall scribing
- Fits 7312 laminate trimmer for 90-degree corner work
- Replaces original sub-base with model 14108
- Compatible with most Porter Cable laminate trimmers
- New Big Horn accessory for precise edge routing
Offset Base for Laminate Trimmers
The Big Horn 14108 Offset Trimmer Sub-Base fits Porter Cable 7312 laminate trimmers. It provides an offset mounting platform that allows the tool to reach areas a standard base cannot. This accessory is for woodworkers and installers who need to trim laminates against vertical surfaces or inside tight corners.
Backsplash and Corner Trimming Capacity
The offset design enables backsplash trimming, wall scribing and trimming 90-degree corners. It handles flush cuts against walls and inside corners where a centred base would hit the obstruction. The base runs out of reach when the workpiece requires a centred bit position or when the trimmer must operate far from the edge without offset clearance.
Stable Mounting in Normal Use
The sub-base secures directly to the compatible trimmer for rigid, vibration-free operation. Normal use produces only the sound and power draw of the host tool itself. No additional cooling or lubrication is required beyond the trimmer’s standard maintenance.
Highlights
- Offset base enables backsplash trimming and wall scribing
- Fits 7312 laminate trimmer for 90-degree corner work
- Replaces original sub-base with model 14108
- Compatible with most Porter Cable laminate trimmers
- New Big Horn accessory for precise edge routing
Specifications
| Brand | BIG HORN |
|---|
Questions about this item
Will the 14108 offset base fit the 7312 laminate trimmer I already own?
The 14108 offset sub-base is designed for the 7312 laminate trimmer and works with most Porter Cable laminate trimmers, so it should mount directly to your existing tool.
How can I confirm the offset base is aligned correctly after installation?
After fitting the base, run a test cut on scrap material; the offset design should let the bit reach tight 90-degree corners and backsplash edges without the motor housing hitting the wall.
Does the 14108 package include mounting hardware or just the base casting?
The box contains the offset trimmer sub-base only; mounting screws or adapters for your specific trimmer model must be sourced separately if not already on the tool.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
