Bernard
Bernard N-5800C Centerfire nozzle 1/2 in
A Centerfire nozzle compatible with Bernard and Miller large-series welding guns
- TypeAngle, Pitch & Slope Locators
- Compatible with Bernard and Miller welding guns
- Fits Large Centerfire series for broad usability
- Works with BTB, Clean Air, Dura-Flux and FILTAIR systems
- Suits Q-Gun, S-Gun, XR-Aluma-Pro and XR-Pistol models
- California Proposition 65 chemical warning applies
Bernard N-5800C Centerfire nozzle
The Bernard N-5800C is a Centerfire nozzle built for Large Centerfire series guns. It fits Bernard and Miller models including BTB, Clean Air, Dura-Flux, FILTAIR, Q-Gun, S-Gun, XR-Aluma-Pro and XR-Pistol. The part is supplied new and carries California Proposition 65 warnings for cancer and reproductive harm.
Suitable guns and limitations
This nozzle suits welders running compatible Large Centerfire equipment who need a direct replacement tip. It will not fit Small Centerfire or other series guns, so owners of those platforms must look elsewhere. Buyers restricted by state sales limits should verify eligibility before ordering.
1/2 in Centerfire nozzle specification
The 1/2 in designation is the critical dimension that decides whether this tip matches the gun. Confirm the series and bore size on the existing hardware before purchasing.
Highlights
- Compatible with Bernard and Miller welding guns
- Fits Large Centerfire series for broad usability
- Works with BTB, Clean Air, Dura-Flux and FILTAIR systems
- Suits Q-Gun, S-Gun, XR-Aluma-Pro and XR-Pistol models
- California Proposition 65 chemical warning applies
Specifications
| Brand | BERNARD |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
Which welding gun series must I already own for this Bernard N-5800C Centerfire nozzle to fit?
It fits Bernard and Miller guns in the Large Centerfire series including BTB, Clean Air, Dura-Flux, FILTAIR, Q-Gun, S-Gun, XR-Aluma-Pro and XR-Pistol models.
Will this nozzle work with my older Bernard or Miller gun that uses a different Centerfire series?
No, it is made for the Large Centerfire series only and will not seal correctly on Small or Standard Centerfire gun bodies.
How can I confirm the nozzle is seated properly after I thread it onto the gun?
The nozzle should thread on smoothly to a firm stop with no cross-threading, and the gas diffuser must sit flush so shielding gas flows evenly around the contact tip.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
