Batianda
Batianda 8-pin Hirose MXR-8P-8P Plug for Sony RCP 920 1500 CCA5-3 Cable (5)
Eight-pin Hirose plug connects Sony RCP, MSU and CNU remote panels to BVP and HDC cameras
- 8-pin Hirose MXR-8P-8P male plug for secure Sony camera control
- Tested for no short circuits or potential breakdown before shipping
- Compatible with RCP-700, RCP-920, RCP-1500 remote panels
- Works with MSU-900, MSU-950 master setup units
- Fits HDCU-1000, HDCU-1500, HDCU-1700, HDCU-2500 CCU cameras
Professional camera control connector
The Batianda 8-pin Hirose MXR-8P-8P male plug provides a direct control interface for Sony broadcast equipment. It connects MSU, RCP and CNU remote controllers to compatible BVP and HDC series cameras. The connector matches the Hirose MXR-8P-8P specification and includes a black cable clamp for secure termination.
Eight-pin Hirose interface limits
The plug uses an eight-pole Hirose MXR-8P-8P connection rated for Sony CCA-5 cable equivalence. It carries control signals between remote panels and camera control units rather than video or power. The interface is defined by Sony broadcast standards and does not support other protocols or connector types.
Five-piece pack for multi-panel setups
A pack of five plugs covers typical multi-camera configurations with several remote control panels. It suits studios using RCP-700, RCP-920 or MSU-900 units alongside HDCU-1000 to HDCU-2500 camera control units. The quantity falls short for large outside-broadcast trucks that run ten or more simultaneous control positions.
Highlights
- 8-pin Hirose MXR-8P-8P male plug for secure Sony camera control
- Tested for no short circuits or potential breakdown before shipping
- Compatible with RCP-700, RCP-920, RCP-1500 remote panels
- Works with MSU-900, MSU-950 master setup units
- Fits HDCU-1000, HDCU-1500, HDCU-1700, HDCU-2500 CCU cameras
Specifications
No published specifications for this item yet.
Questions about this item
Should I pick this 8-pin plug for a CCA-5 cable or a different connector type?
This plug matches the CCA-5 cable specification and Hirose MXR-8P-8P pinout, so it fits the control cable used with the listed Sony remote panels.
What does the 8-pin Hirose connection actually carry when I hook it to an RCP-920?
It carries the serial control link between the RCP-920 panel and the CCU, letting the operator adjust camera settings over the CCA-5 cable.
Is the MXR-8P-8P interface limited to the RCP-920 or does it work with other panels?
The same 8-pin Hirose interface fits RCP-700, 701, 750, 751, 920, MSU-900, 950 and CNU-700 units.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
