Barrow Mods
Barrow Mods 2 in 1 accessory 0B 7 pin male to 3.5mm for Canon C200 C300 MKII
Run/stop cable with a 0B 7-pin male plug and a 3.5 mm connector, 24 inches long, for Canon C200 and C300 MKII cameras using a Tilta Nucleus-M system
- Run/stop control for Canon C200 and C300 MKII via Nucleus-M
- 0B 7-pin male to 3.5 mm 4-knot connector for direct motor link
- 60 cm cable length suits typical rig layouts
- Designed exclusively for Nucleus-M hand units and handles
- Tested compatible with major-brand camera systems
Compatible cameras
This cable connects a Tilta Nucleus-M system to Canon C200 and C300 Mark II cameras. It provides run/stop control directly from the Nucleus-M hand grips or FIZ unit. The 0B 7 pin male plug links to the motor port while the 3.5 mm four-contact plug fits the camera remote terminal. It is built for professional camera rigs that need integrated start/stop operation.
Who this suits
Operators using a Nucleus-M hand unit with the listed Canon models gain tethered run/stop without extra adapters. The 60 cm length keeps cables tidy on a shoulder rig or gimbal. Builders who need a different camera connector, a longer reach, or run/stop for non-Nucleus systems should look at other cables. This item does not support cameras outside the C200 and C300 Mark II pairing.
0B 7 pin to 3.5 mm connector
The decisive specification is the plug pairing: 0B 7 pin male on one end and a 3.5 mm four-contact connector on the other. Only cameras with that exact remote port and a Nucleus-M motor port will work. The 24 inch cable length is fixed unless a custom order is arranged. Verify both ports on your gear before purchase.
Highlights
- Run/stop control for Canon C200 and C300 MKII via Nucleus-M
- 0B 7-pin male to 3.5 mm 4-knot connector for direct motor link
- 60 cm cable length suits typical rig layouts
- Designed exclusively for Nucleus-M hand units and handles
- Tested compatible with major-brand camera systems
Specifications
No published specifications for this item yet.
Questions about this item
Does the 0B 7-pin male connector draw noticeable power or generate heat during all-day shoots?
The cable is a passive link between the Nucleus-M motor port and the camera's 3.5 mm run/stop input, so it adds no active electronics, draws no measurable power and produces no heat.
What equipment must I already own for this 24-inch run/stop cable to function?
You need a Tilta Nucleus-M system — either the hand unit or FIZ unit — plus a compatible motor with a 0B 7-pin port, and a Canon C200 or C300 Mark II camera with a 3.5 mm remote terminal.
Will this 60 cm cable work if I keep using my older Canon C100 or a different brand's 3.5 mm remote port?
The run/stop function is engineered specifically for the Nucleus-M talking to a Canon C200 or C300 Mark II; other cameras with a 3.5 mm jack will not trigger record start/stop through this cable.
New to this? Buying a laptop with crypto, start to finish — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
