We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Axiom QSFP28 transceiver module, matte metal finish, LC duplex ports

Axiom

Axiom QSFP-100G-LR-JNP-AX 100GBASE-LR QSFP28 SFP transceiver

SKU CH-NF1Z-FB1YT MPN QSFP-100G-LR-JNP-AX

A QSFP28 transceiver for 100GBASE-LR links over single-mode fiber up to 10km at 1310nm

  • QSFP28 form-factor fits 100G ports directly
  • 100GBASE-LR interface reaches 10 km on single-mode fiber
  • LC duplex connector uses 1310 nm wavelength for reliable links
  • Digital Optical Monitoring gives real-time link health visibility
  • Operates from 0 °C to 70 °C for standard data-centre environments

100GBASE-LR QSFP28 transceiver

This Axiom QSFP28 module provides a 100 Gbps single-mode fiber link up to 10 km. It is built for network engineers deploying long-reach connections in Juniper routing and switching platforms.

Replaces OEM LR optics in Juniper gear

The module is pre-coded for Juniper compatibility and meets MSA standards, so it fits directly into existing QSFP28 ports. The upgrade is worthwhile when an operator needs a 10 km reach at 1310 nm without purchasing vendor-branded optics.

Hot-pluggable LC duplex installation

Installation follows standard QSFP28 hot-swap procedure into an LC duplex patch panel. The main risk is inserting the transceiver into a multimode port or exceeding the 0 °C to 70 °C operating range, which will cause link failure.

Highlights

  • QSFP28 form-factor fits 100G ports directly
  • 100GBASE-LR interface reaches 10 km on single-mode fiber
  • LC duplex connector uses 1310 nm wavelength for reliable links
  • Digital Optical Monitoring gives real-time link health visibility
  • Operates from 0 °C to 70 °C for standard data-centre environments

Specifications

No published specifications for this item yet.

Questions about this item

Does this QSFP28 transceiver fit a standard LC duplex patch panel?

Yes, it uses an LC duplex connector designed for G652 single-mode fiber, so it plugs directly into any standard LC duplex bulkhead or patch panel.

What is the correct insertion procedure for the QSFP28 module, and what step is often missed?

Slide the module into the switch port until the latch clicks, then remove the dust caps and insert the LC duplex cables; the step often missed is removing the dust caps before cabling.

When should the 1310nm optics be cleaned or the module replaced?

Clean the LC ferrules with a single-mode fiber cleaner whenever signal loss rises or DOM alarms appear; replace the module if errors persist after cleaning or if it exceeds the 0°C to 70°C operating range.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.