Attwood
Attwood 66319G7 1-Mile Green Sidelight 12V Stainless Steel Housing
A green 12 V sidelight with a 304 stainless-steel housing that gives one-mile, 112.5-degree visibility for power boats up to 39.4 ft
- ColorGreen
- Color MappingGreen
- GenderUnisex
- One-mile visibility for boats up to 39.4 ft
- Corrosion-resistant 304 stainless steel housing
- 5-degree light spread covers required sector
- Includes 7.5-watt lamp for 12 VDC systems
- Green sidelight meets navigation colour standard
Green sidelight for power boats
This green sidelight is built for power boats up to 39.4 ft that need one-mile visibility. It runs on a 12 VDC supply and meets the 112.5 degree sector required for navigation. The 7.5 watt lamp is included so the unit is ready to wire once mounted.
304 stainless housing with sealed lens
The housing uses corrosion-resistant 304 stainless steel to withstand marine exposure. A rubber gasket seals the lens against water ingress, protecting the internal contacts from salt spray. Three #6 fasteners secure the base to the deck, though the screws are not supplied with the light.
Single wire lead simplifies installation
A single 7 wire lead connects the lamp to the boat's 12 VDC system, keeping the wiring run straightforward. No separate controller or converter is bundled, so the light integrates directly into existing navigation circuits. The package contains the fixture, lens seal and lamp only.
Highlights
- One-mile visibility for boats up to 39.4 ft
- Corrosion-resistant 304 stainless steel housing
- 5-degree light spread covers required sector
- Includes 7.5-watt lamp for 12 VDC systems
- Green sidelight meets navigation colour standard
Specifications
| Brand | Attwood Marine |
|---|---|
| Color | Green |
| Color Mapping | Green |
| Gender | Unisex |
Questions about this item
What voltage does the 66319G7 sidelight require and how is it wired?
The light operates on a 12 VDC power supply and includes a 7-inch wire lead for the electrical connection.
What mounting hardware and hole pattern does the stainless housing need?
Installation uses three #6 fasteners, which are not included with the light.
How do you seal the lens during installation to keep water out?
A rubber gasket sits between the lens and the 304 stainless housing; it must be seated evenly before the three #6 screws are tightened.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Tour Edge Golf Mfg. Inc. pdprsu0138 golf accessory
- Toys and Games



