ATPAZDB
ATPAZDB NV133FHM-T0A laptop screen 13.3" FHD 1920x1080 40-pin touch
A 13.3 inch Full HD touchscreen replacement panel with 40-pin connector, 60 Hz refresh rate and 250 cd/m² brightness
- Compatible ModelsNV133FHM-T0A
- Screen Size13.3 inch
- Screen ResolutionFull HD (FHD) 1920x1080
- 3 inch FHD clarity for sharp visuals
- 40-pin connector ensures direct fit
- Touch layer enables fingertip control
- 250 cd/m² brightness suits indoor use
- 60 Hz refresh handles everyday tasks
13.3-inch touch display panel
This replacement screen measures 13.3 inches diagonally and delivers Full HD 1920x1080 resolution with a 60Hz refresh rate. It connects through a 40-pin video signal connector and includes integrated touch functionality. Brightness reaches 250 cd/m² with an 800:1 contrast ratio.
Repair technicians and DIY upgraders
Suits anyone replacing a damaged NV133FHM-T0A panel in a compatible laptop. Not for buyers whose device uses a different connector pin count, a non-touch variant, or a different screen size.
40-pin connector with touch support
The single specification that determines compatibility is the 40-pin video signal connector combined with touch capability. Verify the original panel matches this exact part number before ordering.
Highlights
- 3 inch FHD clarity for sharp visuals
- 40-pin connector ensures direct fit
- Touch layer enables fingertip control
- 250 cd/m² brightness suits indoor use
- 60 Hz refresh handles everyday tasks
Specifications
| Part Number | NV133FHM-T0A |
|---|---|
| Compatible Models | NV133FHM-T0A |
| Screen Size | 13.3 inch |
| Screen Resolution | Full HD (FHD) 1920x1080 |
Questions about this item
Will the 250 cd/m² brightness hold steady during an all-day work session?
The panel is rated at 250 cd/m² and 60 Hz, with no separate thermal throttle point published, so brightness remains at the rated level under normal continuous use.
Does the 40-pin connector run warm or draw extra power when the touch layer is active all day?
The 40-pin eDP interface carries both video and touch signals at standard low-voltage levels; no additional heat or power draw beyond the panel's normal 250 cd/m² operation is specified.
Besides a 40-pin eDP cable, do I need a separate touch-controller board or driver dongle for the touch function to work?
Touch data travels through the same 40-pin connector, so a compatible 40-pin cable and a motherboard that supports the panel's touch protocol are the only requirements.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



