Astro Pneumatic
Astro Pneumatic 7865 ball joint service kit 4WD Dana 44 1967+ 16.5in 7.5lb
Removes and installs press-fit ball joints on 1967+ Dana 44 4WD axles with included C-frame press and adapters in a hard case
- Services 1967+ Dana 44 4WD axles
- Removes rusted ball joints without damage
- Includes C-frame press and three receiver tubes
- Hard blow-moulded case protects all components
- Compact 16.5 in length weighs 7.5 lbs
Ball Joint Service Kit for Dana 44 Axles
The Astro Pneumatic 7865 kit provides the tools required to remove and install press-fit ball joints on 1967 and newer half- and three-quarter-ton four-wheel-drive vehicles equipped with a Dana 44 front axle. It covers Ford, GM, Dodge, IHC and Jeep applications and includes a C-frame press, three receiver tubes, installation and removal adapters, and a blow-moulded hard case.
Installation Uses a C-Frame Press and Receiver Tubes
The C-frame press mounts over the axle housing while the selected receiver tube supports the opposite side, allowing the forcing screw to press the joint in or out. Rust and corrosion on older vehicles can increase the force needed, so penetrating oil and a clean work area help prevent stuck adapters or damaged threads during the job.
Heavy-Duty Construction Handles Repeated Pressing
The steel components are built to withstand the high loads required to free seized joints without bending or cracking. The 16.5 in. overall length and 7.5 lb. weight give enough leverage for sustained pressing cycles on multiple vehicles, and the hard case keeps the adapters organised between jobs.
Highlights
- Services 1967+ Dana 44 4WD axles
- Removes rusted ball joints without damage
- Includes C-frame press and three receiver tubes
- Hard blow-moulded case protects all components
- Compact 16.5 in length weighs 7.5 lbs
Specifications
No published specifications for this item yet.
Questions about this item
How do I confirm the C-frame press is aligned correctly on a Dana 44 axle before pressing?
The C-frame press and receiver tubes seat squarely on the axle housing; when the forcing screw turns smoothly and the joint moves evenly without binding, the setup is working as intended.
Which adapters and tubes come in the 7865 kit for 1967+ Dana 44 4WD service?
The kit includes the C-frame press, three receiver tubes (2-3/4×3 in., 2-1/4×2-1/2 in., 1-3/4×2 in.), an installation adapter, a removing adapter, a 4-wheel drive ball joint adapter, and a hard blow-molded case.
Should I choose the 7865 kit for a 1967-current 1/2- or 3/4-ton 4WD with a Dana 44 front axle?
Yes — the 7865 kit is built specifically for 1967 through current 1/2- and 3/4-ton 4-wheel-drive vehicles equipped with a Dana 44 front axle on Ford, GM, Dodge, IHC and Jeep platforms.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
