ARTU USA INC
ARTU USA INC 01250 SDS Plus Drill Bit 7/16" x 6.000"L
SDS Plus drill bit with 7/16 inch diameter, 6 inch overall length, and 4 inch maximum drilling depth
- SDS Plus shank fits compatible rotary hammers directly
- 7/16 inch diameter drills precise holes in masonry
- 6 inch overall length reaches deeper work areas
- 4 inch maximum drilling depth handles thick materials
- Chrome vanadium steel resists wear for longer life
SDS Plus 7/16 inch bit for concrete work
This SDS Plus drill bit has a 7/16 inch diameter and a 6.000 inch overall length. It is designed for rotary hammers that accept SDS Plus shanks. The CrV steel construction suits repetitive drilling in masonry and concrete.
Check shank fit and depth before ordering
Verify that your rotary hammer uses an SDS Plus chuck because the 3/8 inch shank diameter will not fit SDS Max or spline systems. The maximum drilling depth is 4 inches so holes deeper than that require a longer bit.
CrV steel resists wear in hard aggregate
The CrV material holds its edge longer than standard carbon steel when drilling reinforced concrete. The SDS Plus shank locks positively into the chuck so the bit will not spin loose during heavy impact cycles.
Highlights
- SDS Plus shank fits compatible rotary hammers directly
- 7/16 inch diameter drills precise holes in masonry
- 6 inch overall length reaches deeper work areas
- 4 inch maximum drilling depth handles thick materials
- Chrome vanadium steel resists wear for longer life
Specifications
| Brand | ARTU |
|---|
Questions about this item
What does the ARTU 01250 SDS Plus drill bit include and is anything else needed?
The bit ships as a single 7/16 inch SDS Plus shank drill; no extra accessories are required for use in a compatible rotary hammer.
How do I decide between the 6.000 inch overall length and the 4 inch drilling depth?
Choose the 6.000 inch overall length when you need reach through thick material; the 4 inch maximum drilling depth tells you how deep the flute can actually cut.
What does the 7/16 inch diameter mean once the bit is in my rotary hammer?
It produces a 7/16 inch hole suitable for anchors or fasteners of that size, and the 3/8 inch shank diameter fits any SDS Plus chuck.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
