We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Anvil 90 degree elbow socket weld fitting 362001802

Anvil

Anvil 90 Degree Elbow 2" Socket Weld 362001802

SKU CH-M6SM-2KATM

Socket-weld elbow changes pipe direction by 90 degrees for water and oil systems

  • TypePlumbing & Pipe Fittings
  • 90-degree turn redirects flow in tight piping layouts
  • Socket-weld design creates a strong, leak-resistant joint
  • Thick-walled construction withstands demanding industrial pressure cycles
  • Suitable for water and oil across chemical, petrochemical and semiconductor plants
  • Anvil 362001802 identifies the exact fitting for reordering

Anvil 2-Inch Socket Weld Elbow

The Anvil 362001802 is a 90-degree socket-weld fitting built for industrial piping systems. Its thick-walled construction provides mechanical strength for demanding fluid-transfer lines. The elbow suits chemical, petrochemical, pulp, paper, shipbuilding, waste-incineration and semiconductor facilities. Installers gain a simple, economical joint for water and oil service.

Socket-Weld Joint Constraints

A socket-weld connection demands precise pipe preparation and skilled welding to achieve a leak-free seal. The fitting is permanent once installed, so layout changes require cutting and replacement. Alignment must be controlled during fit-up to avoid stress on adjacent pipe runs. The method is unsuitable for systems that require frequent disassembly.

Flow Capacity and Pressure Headroom

The 90-degree bend introduces a moderate pressure drop that designers must account for in long runs or high-velocity service. Thick walls give ample margin for the pressures common in water and oil circuits within the listed industries. The fitting handles standard process temperatures for those fluids without degradation. Extremely high-flow or abrasive-slurry applications may exceed its practical service life.

Highlights

  • 90-degree turn redirects flow in tight piping layouts
  • Socket-weld design creates a strong, leak-resistant joint
  • Thick-walled construction withstands demanding industrial pressure cycles
  • Suitable for water and oil across chemical, petrochemical and semiconductor plants
  • Anvil 362001802 identifies the exact fitting for reordering

Specifications

TypePlumbing & Pipe Fittings
BrandAnvil

Questions about this item

Should I select the 90 degree elbow in the 2 inch size for my piping run?

The Anvil fitting is a 90 degree elbow with a 2 inch socket-weld end, so choose it when your pipe schedule matches that diameter and you need a right-angle turn.

How does the 90 degree angle affect flow once the elbow is welded into the line?

The 90 degree bend changes flow direction by a right angle; pressure drop will depend on the pipe schedule and fluid velocity in your specific system.

What does the socket weld connection mean for installation and pressure rating?

The socket weld end requires a fillet weld around the pipe OD, providing a strong joint suitable for the pressure class of the matching pipe schedule.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.