We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Malleable iron 90 degree street elbow 1/4 FNPT threads

Anvil

Anvil 0310015805 90 Degree Street Elbow 1/4" FNPT trap

SKU CH-70C2-SHEQ3 MPN 0310015805

A 90-degree street elbow with 1/4-inch FNPT threading connects pipes at a right angle in plumbing systems

  • TypeDrain Components
  • MaterialHAWA
  • 90° street elbow redirects flow in tight plumbing runs
  • Malleable iron body rated for 300 psi at 150 °F
  • Class 150 Schedule 40 threading matches standard 1/4" pipe
  • Female NPT to male NPT ends simplify installation
  • New Anvil fitting ready for immediate service

Anvil 90° Street Elbow 1/4" FNPT

This Anvil malleable iron street elbow connects a 1/4 inch female NPT thread to a 1/4 inch male NPT thread at a 90 degree angle. It is rated for Schedule 40 pipe and Class 150 service at 300 psi maximum operating pressure at 150 degrees F. The fitting suits plumbing and hydronic systems requiring a compact directional change.

Installation uses standard NPT threading

Apply thread sealant or tape to the male threads before engaging the female end. Tighten to the recommended turns past finger-tight for NPT connections to prevent leaks. Over-tightening can crack the malleable iron casting or distort the threads, while insufficient sealant causes weeping at the joint.

Sustained pressure and temperature performance

The Class 150 rating supports continuous operation at 300 psi up to 150 degrees F without degradation. Malleable iron resists vibration and thermal cycling better than cast iron in heating loops. The fitting maintains seal integrity under steady load rather than only brief test pressure.

Highlights

  • 90° street elbow redirects flow in tight plumbing runs
  • Malleable iron body rated for 300 psi at 150 °F
  • Class 150 Schedule 40 threading matches standard 1/4" pipe
  • Female NPT to male NPT ends simplify installation
  • New Anvil fitting ready for immediate service

Specifications

TypeDrain Components
MaterialHAWA
BrandAnvil
Model0310015805

Questions about this item

How can I confirm the 90 degree street elbow is installed correctly and leak-free?

Pressure-test the assembly up to 300 psi at 150 degrees F; a hold with no pressure drop confirms the FNPT and MNPT threads are sealing properly.

What comes in the box and what must I supply separately?

The box contains the single malleable-iron 1/4 inch Class 150 street elbow; you must provide Schedule 40 pipe, thread sealant and any required nipples or fittings.

Which version of the Anvil 0310015805 should I choose for a 1/4 inch Schedule 40 system?

This model is the only version listed — a 90 degree street elbow with 1/4 inch FNPT by 1/4 inch MNPT threads, rated Class 150 for Schedule 40 pipe.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.