We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White PTFE thread sealant tape roll 1/2 inch by 260 inches

Anti-Seize

Anti-Seize 46230 Thread Sealant Tape 1/2 in x 260 in

SKU CH-JHMV-S3EVQ

White PTFE thread-sealant tape, 1/2 in wide by 260 in long, rated to 10,000 psi liquid and 2,000 psi gas pressure from -400 °F to 550 °F

  • ColorWhite
  • Seals threads reliably with general-purpose pipe tape
  • Handles extreme cold down to -400°F operating temperature
  • Withstands high heat up to 550°F maximum temperature
  • Resists liquid pressure to 10,000 psi rating
  • Dense PTFE construction between 1.2 and 1.5 g/cc

General-purpose pipe thread tape

This PTFE thread sealant tape is designed for general-purpose pipe sealing on metal and plastic fittings. It suits plumbers, maintenance technicians and DIY users who need a reliable joint seal on water, air or gas lines. The tape is rated for threads up to 1 1/2 in diameter.

Temperature and pressure performance

The tape operates continuously from -400 Degrees F to 550 Degrees F without degrading. It withstands liquid pressures up to 10,000 psi and gas pressures up to 2,000 psi. Linear density ranges between 1.2 and 1.5 g/cc for consistent fill and low permeation.

Dimensions and daily handling

Each roll measures 1/2 in wide by 260 in long, providing 21 ft of material per roll. The white colour makes coverage easy to inspect on threaded joints. It is not intended for oxygen service or for sealing non-threaded surfaces such as flanges or compression fittings.

Highlights

  • Seals threads reliably with general-purpose pipe tape
  • Handles extreme cold down to -400°F operating temperature
  • Withstands high heat up to 550°F maximum temperature
  • Resists liquid pressure to 10,000 psi rating
  • Dense PTFE construction between 1.2 and 1.5 g/cc

Specifications

ColorWhite
BrandANTI-SEIZE TECHNOLOGY

Questions about this item

How do I apply the 1/2 in wide POLY-TEMP XHD tape to threads up to 1 1/2 in diameter without gaps?

Wrap the tape clockwise around clean male threads with slight tension, overlapping each turn by half the 1/2 in width, and press firmly so the 1.2 to 1.5 g/cc density material fills the thread roots before assembly.

When should I replace the tape on a joint that sees repeated thermal cycling between -400 °F and 550 °F?

Replace the tape whenever the joint is broken or if visual inspection shows the white PTFE has thinned, shredded, or lost its ability to maintain a seal at up to 10,000 psi liquid or 2,000 psi gas pressure.

At what sustained pressure will the seal on a 1 1/2 in fitting reach its limit first?

The gas rating of 2,000 psi is the lower limit, so sustained gaseous pressure above that value will challenge the seal before the 10,000 psi liquid rating becomes a factor.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.