We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black sealed enclosure with 10-inch subwoofer driver, custom-fit for Jeep Wrangler JKU under-seat installation

Alpine

Alpine SBV-10-WRA 10-Inch Car Subwoofer for 2007-2018 Jeep Wrangler JKU

SKU CH-1Y74-W29TW

A 10-inch subwoofer pre-loaded into a sealed, custom-fit enclosure installs under the front passenger seat of 2007-2018 Jeep Wrangler JKU models with an IP66 rating and 300W RMS power handling

  • TypeEnclosures
  • Pre-loaded 10-inch subwoofer in a sealed custom-fit enclosure
  • Pressure-fit under the front passenger seat rails without mounting hardware
  • IP66 rated for total dust ingress and water protection
  • OEM-grade weather-resistant Molex 2-pin connector with pigtail wire harness
  • 300W RMS and 900W max power handling matched to KTA-30MW amplifiers

Vehicle-Specific Subwoofer

The Alpine SBV-10-WRA is a 10-inch subwoofer pre-loaded into a sealed, custom-fit enclosure built for 2007-2018 Jeep Wrangler JKU models. It uses a pressure-fit design that sits under the front passenger seat rails without mounting hardware. The enclosure carries an IP66 rating for total dust protection and resistance to water from any direction.

Wrangler Owners Seeking Factory-Fit Bass

This unit suits drivers who want impactful bass with the top on or off while keeping cabin space intact. The subwoofer loads lower frequencies into the passenger footwell for consistent extension. Buyers who need more storage under the seat or who have removed the factory carpet should look elsewhere, as fitment is not guaranteed without the original carpet.

Pressure-Fit Installation With Connector

Installation relies on sliding the enclosure under the seat frame until it seats firmly; no brackets or bolts are required. The OEM-grade weather-resistant Molex 2-pin connector with pigtail harness simplifies wiring to a compatible amplifier. The most common issue is a loose fit or rattling when the factory carpet is missing or replaced with aftermarket floor liners.

Highlights

  • Pre-loaded 10-inch subwoofer in a sealed custom-fit enclosure
  • Pressure-fit under the front passenger seat rails without mounting hardware
  • IP66 rated for total dust ingress and water protection
  • OEM-grade weather-resistant Molex 2-pin connector with pigtail wire harness
  • 300W RMS and 900W max power handling matched to KTA-30MW amplifiers

Specifications

TypeEnclosures

Questions about this item

What amplifier power rating should I already have to match this 300W RMS subwoofer?

Alpine recommends pairing it with a mono amplifier rated around 300W RMS such as the KTA-30MW for optimal performance.

Will the IP66-rated enclosure survive alongside my older factory carpet and seat rails?

Yes, the sealed IP66 enclosure is pressure-fit under the front passenger seat rails and designed for Jeeps retaining the factory carpet.

How can I confirm the subwoofer is reproducing its full 45-200Hz range after installation?

Play a frequency sweep from 45 Hz to 200 Hz; you should hear clean, even output across the entire band without gaps or rattles.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.