Alphacool
Alphacool M12 to M8 4Pin A-Code Male to 3Pin Female Cable 2M AWG22
M12 4-pin A-code male to M8 3-pin female cable, 2 m length, AWG22, IP67 rated, thread locking, IEC 61076-2-101 compliant
- M12 A-code male to M8 3-pin female connects industrial sensors
- 2 metre AWG22 cable reaches distant devices without extension leads
- Thread locking coupling resists vibration in moving machinery
- IP67 rating protects against dust and temporary immersion
- Rated 30 V at 1.5 A for low-voltage control circuits
Connector type and length
The Alphacool M12 to M8 cable carries a 4-pin A-code male connector on one end and a 3-pin female socket on the other. It spans two metres and uses AWG22 conductors rated for 1.5 A at 30 V. The thread-locking coupling meets IEC 61076-2-101 and provides an IP67 seal. It suits industrial sensor or actuator runs that need a robust, vibration-resistant link.
Who this suits and who should look elsewhere
Builders wiring M12-compatible field devices in tight cabinets will appreciate the straight, double-ended layout and the -40 °C to +90 °C operating range. Buyers who need a different pin count, a right-angle hood, or a longer reach than two metres should look at other cable assemblies. The 5 mΩ contact resistance and 100 MΩ insulation resistance are fixed by the specification.
Behaviour under sustained load
The AWG22 conductors and 30 V rating keep voltage drop predictable during continuous 1.5 A operation. The IP67-rated thread lock maintains seal integrity when the cable is routed through damp or wash-down zones over long periods. Insulation resistance of 100 MΩ remains stable across the full -40 °C to +90 °C ambient range, so the link stays reliable in extended thermal cycling.
Highlights
- M12 A-code male to M8 3-pin female connects industrial sensors
- 2 metre AWG22 cable reaches distant devices without extension leads
- Thread locking coupling resists vibration in moving machinery
- IP67 rating protects against dust and temporary immersion
- Rated 30 V at 1.5 A for low-voltage control circuits
Specifications
No published specifications for this item yet.
Questions about this item
Will the M12 4-pin A-code male end mate with my existing M12 A-code 4-pin female port?
Yes, the M12 4-pin A-code male connector follows the IEC 61076-2-101 standard and uses a 12 mm thread-locking coupling for a secure fit.
Can I run this 2 m AWG22 cable alongside legacy 5 V sensor wiring without signal issues?
The cable is rated for 30 V and 1.5 A with 5 mΩ contact resistance and 100 MΩ insulation resistance, keeping crosstalk low near older low-voltage looms.
How do I verify the IP67 seal is intact after I connect the M8 3-pin female socket?
Confirm the M8 coupling is fully threaded home and inspect the overmoulded joints; the assembly is rated for -40 °C to +90 °C ambient operation.
New to this? Buying a laptop with crypto, start to finish — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
