Adafruit
Adafruit 4 Gauge CCA Wiring Kit 50ft Black/Red with Lugs Fuse Heat Shrink 2 in 1 Accessories
Supplies 50 ft of 4-gauge CCA power and ground cable with lugs, heat-shrink tubing and a 100 A ANL fuse block for car audio, RV or 12 V inverter installations
- Economical power transfer with copper-clad aluminium construction
- Complete kit includes 50 ft cable, 20 lugs, 20 heat-shrink tubes and 100 A fuse
- Flexible PVC jacket resists impact and suits indoor routing
- Ready for amplifier, subwoofer or 12 V inverter installations
- 25 ft each of red and black wire for clear polarity identification
4 Gauge CCA Wiring Kit 50 ft
This kit supplies 50 feet of 4 gauge copper clad aluminum wire in black and red, plus lugs, heat shrink tubing and a 100 A ANL fuse block. It is aimed at installers who need an economical power or ground cable for car audio, RV or 12 V inverter projects. The CCA construction keeps cost low while still delivering solid current transfer for moderate loads.
Suits budget conscious installers not high current
The kit works well for amplifier wiring, subwoofer power, indoor lighting or general 12 V distribution where extreme current is not required. Builders who need maximum conductivity for competition grade systems or very long runs should consider oxygen free copper alternatives instead.
100 A ANL fuse block included
The supplied 100 A ANL fuse holder is the single spec that determines whether the kit can protect your circuit at the intended current level. Verify that your amplifier or load does not exceed this rating before installation.
Highlights
- Economical power transfer with copper-clad aluminium construction
- Complete kit includes 50 ft cable, 20 lugs, 20 heat-shrink tubes and 100 A fuse
- Flexible PVC jacket resists impact and suits indoor routing
- Ready for amplifier, subwoofer or 12 V inverter installations
- 25 ft each of red and black wire for clear polarity identification
Specifications
No published specifications for this item yet.
Questions about this item
What lug stud sizes are included for the 4 gauge CCA wire?
The kit provides ten lugs with 5/16 inch stud holes and ten lugs with 3/8 inch stud holes, both sized for AWG4 cable.
How do you properly secure the lugs and protect the connections during installation?
Crimp each lug onto the stripped CCA conductor, then slide the supplied heat-shrink tubing over the joint and apply heat until it seals tightly.
Which component in the kit would need replacement if the circuit experiences a sustained over-current event?
The 100A ANL fuse block contains the sacrificial fuse element that must be swapped after it blows to restore protection.
New to this? Buying a laptop with crypto, start to finish — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
