Adafruit
Adafruit 4.7 Inch 5V/12V Dual Voltage Gooseneck Ventilation Fan 2 in 1 Accessory
A 4.7 inch gooseneck fan with IP54 waterproofing, six speeds, timer cycles, and 5V/12V dual voltage for grow tents and pet enclosures
- Customise airflow with 6 speed levels
- Automate ventilation using 16-hour delay and 12H, 24H cycle modes
- Power from 5V USB or 12V DC with included adapter
- IP54 waterproof motor rated for 60000 hours
- Direct air anywhere with 360-degree flexible gooseneck
Dual-voltage gooseneck fan for grow tents
This 4.7 inch accessory runs on 5V USB or 12V DC power with an included adapter. The flexible gooseneck directs airflow precisely where needed inside grow tents, greenhouses, cabinets or pet crates. IP54 waterproof and dust-proof construction with dual ball bearings supports a 60000 hour service life in humid or dusty conditions.
Suits growers and pet owners needing automated
Six speed levels and a smart timer with 16 hour delay-off plus 12H, 24H and non-cycle modes automate daily airflow and odor control. Daisy-chain support lets you link up to 8 units from one controller for larger spaces. Not suited for builders who need high-static-pressure duct fans or silent PC case cooling.
Handles tents, crates
At 5V the motor spins at 4001700 RPM for gentle circulation; at 12V it reaches 10003000 RPM for stronger cooling. Headroom ends when the daisy-chain reaches its maximum or when the gooseneck length cannot span the required distance.
Highlights
- Customise airflow with 6 speed levels
- Automate ventilation using 16-hour delay and 12H, 24H cycle modes
- Power from 5V USB or 12V DC with included adapter
- IP54 waterproof motor rated for 60000 hours
- Direct air anywhere with 360-degree flexible gooseneck
Specifications
No published specifications for this item yet.
Questions about this item
What power source do I need to run the fan at 10003000 RPM?
A 12 V DC supply is required for the 10003000 RPM speed; the box includes a USB-to-DC adapter so you can also run it from a 5 V USB port at 4001700 RPM.
Can I connect this fan to an existing 12 V DC rail in my enclosure?
Yes — the fan accepts 12 V DC directly, and the plug-and-play controller supports daisy-chaining up to 8 units on the same rail.
How can I verify the fan is operating correctly after I install it?
The motor should spin smoothly at the selected speed, the controller LEDs indicate the active timer mode, and the IP54-rated housing remains sealed against dust and splashes during operation.
New to this? Buying a laptop with crypto, start to finish — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
