ABLEGRID
ABLEGRID 6.6ft 2-Prong AC Power Cord for Harman Kardon AVR 354 430 525 745
A 6.6 ft two-prong AC power cord compatible with Harman Kardon AVR 354, 430, 525 and 745 receivers
- Battery TypeUPS
- Ready for Harman Kardon AVR 354 430 525 745
- UL Listed safety tested for reliable operation
- 6 ft length gives flexible placement options
- Black two-prong design matches original equipment look
- Brand new ABLEGRID cable built for daily use
Compatible A/V receiver power cord
This ABLEGRID cable replaces the mains lead for Harman Kardon AVR 354 430 525 745 receivers. It is a brand new, non‑OEM cord built to UL safety standards. The 6.6ft length gives flexible placement near a wall outlet. The package includes one black power cable.
Passive cable thermals and noise
As a passive mains cord it generates no fan noise and draws no power itself. The only heat comes from normal conductor resistance under load. UL listing confirms the insulation and conductors meet recognised safety requirements. No active cooling or power circuitry is present.
Upgrades worn or missing original leads
Use this cord when the factory cable is lost, damaged or too short for a new rack layout. The jump is worth it if the original plug fits poorly or the jacket shows cracking. Buyers who need a different connector type or a longer run than 6.6ft should look elsewhere.
Highlights
- Ready for Harman Kardon AVR 354 430 525 745
- UL Listed safety tested for reliable operation
- 6 ft length gives flexible placement options
- Black two-prong design matches original equipment look
- Brand new ABLEGRID cable built for daily use
Specifications
| Brand | ABLEGRID |
|---|---|
| Battery Type | UPS |
Questions about this item
How do I connect the 2-prong plug to my Harman Kardon AVR 354 receiver?
Align the non-polarised blades with the AC inlet on the rear panel and push firmly until fully seated; the common mistake is leaving a small gap that causes intermittent power.
When should I replace this 6.6ft AC power cord?
Replace the cord if the insulation shows cracking, the plug blades become loose or discoloured, or after any incident where the cable was pinched or overheated.
What is the first limitation I will hit during continuous use with my AVR 430?
The 2-prong, non-grounded design is the limiting factor; it cannot dissipate fault current, so sustained high draw may trip the receiver's internal protection before the cord itself fails.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



